Hunting Camera / Camera Trap Num'axes 4G PIE 1051 EMAIL
Store Availability
Store Availability
BENEFITS
Easy reading
Date, time and temperature visible on each photo
Ease of use
Built-in SIM to send by email only. Compatible with other SIMs for MMS messages
Fast acting
Trigger speed of 0.5 seconds
Image quality
Up to 24-megapixel photo resolution / FULL HD 1,080 P (1920 x 1080) videos
Distance
Detection and illumination up to 20 metres away
Visual efficiency
Black LED flash invisible to animals at night
Connectivity
Receive the photos by email in the Num'axes application (only with subscription)
TECHNICAL INFORMATIONS
SIM card and subscription
The camera comes with a multi-operator data SIM card.
Compatible with mobile phone operators for optimal coverage. 4 photo transmission packs are available (see photo).
When you insert the standard-sized SIM card, the camera automatically detects the operator and configures the corresponding settings for sending photos (works in 3G and 4G).
The camera can be remotely configured and operated, thanks to the NumCam mobile application.
Taking photos
Image resolution: from 8MP to 24MP: can be sent by email
Video resolution: HD 1280 x 720 p | Full HD 1920 x 1080 p: cannot be sent
Videos with sound, adjustable in length from 5 seconds to 59 seconds.
Burst 1 - 10 photos
Trigger speed 0.5 sec
Photo + Video with audio: a still photo then a video are captured at each trigger
Setup / Mounting Instructions
Make sure that the capture zone in front of the lens is clear (no branches, bushes, etc.) to avoid taking unwanted pictures without any animals.
You should preferably face north or south to avoid low sun rays at sunrise and sunset that can interfere with the photo or the video.
Install the camera at a height of about 1.5 m / 2 m, pointing slightly downwards.
Starting up
Once you have made the necessary adjustments, you can switch the camera ON. A red light on the front of the camera flashes for 5 seconds to let you know it's working, giving you time to close the box and leave the area.
In the settings menu, the camera switches to standby automatically after 3 minutes without pressing a button.
Detection
Sensor range is 20 m
The range of the invisible black LED flash (940 nm) is 20 m
The camera is invisible when triggered at night, with no visible light
The flash can be adjusted to avoid overexposure at night or if you want to place the camera close to the subject (auto, medium, low, off).
PIR interval between 2 photos/videos can be set from 5 sec to 59 min 59 sec (default 20 sec)
Sensor sensitivity can be set to high, medium or low.
Photo angle: 100°
PIR interval adjustment
PIR interval between 2 images adjustable from 5 seconds to 23 hours 59 minutes 59 seconds
If the PIR interval is set to 01:00, the camera will wait 1 minute between each photo/video recording even if motion is detected.
- Short PIR interval = many photos/videos taken = high energy consumption
- Long PIR interval = fewer photos/videos taken = lower energy consumption.
Sensitivity adjustment
Adjustable sensitivity: High | Medium | Low
In a high-temperature environment, the body heat of subjects is difficult for the camera to differentiate from the ambient heat, so high sensitivity is recommended.
It is advisable to use low sensitivity in an environment with a lot of interference such as hot wind, smoke, near a window, etc.
Night mode and flash setting
Maximum range: a longer exposure time to extend the range of the infrared flash for better night vision (inferior image quality)
Minimum blur: a shorter exposure time to minimise blur due to movement and for a superior image quality, but a reduced flash range
Time lapse and time range
The camera can be set to time lapse: 1 photo every X seconds, minutes, hours, depending on your preference: from 5 sec to 23hr 59 min 59 sec.
Note that this deactivates the motion detector.
You can set 2 operating time periods according to your preference. The camera will then only take photos/videos within the defined range(s). For example, from 3pm to 6pm and from 7am to 9am. Compatible with time lapse and motion detector.
Viewing the photos
Imprint on photos and videos: time, date, temperature, moon phase, camera serial number, battery charge level
2.4-inch (~ 5 cm) TFT colour LCD screen for settings and viewing photos and videos
USB 2.0 port for downloading files to a computer
Memory
SD or micro SD card with 4 Gb to 32 Gb adapter, class 10 minimum (not supplied)
Loop recording: ON | OFF
With the Loop recording parameter set to ON, when the memory card is full, the camera will continue to record new photos/videos while deleting the oldest photos/videos.
Batteries and power
4 x LR6/ AA batteries not included. Battery life of 8 months in standby mode.
Compatible with Ni-MH rechargeable batteries.
The device can be used with an external power supply (12V/2A).
NUM'AXES offers a 12V solar panel with integrated lithium battery as an accessory (ref. NGPIEACC038). In this case, the energy from the solar panel takes priority, but you still need to install batteries if there is a prolonged lack of sunlight.
Technical characteristics
Waterproof case: IP66
Operating temperature range -25°C to +60°C
292 g (without batteries) | 476 g (with batteries)
128 x 96 x 76 mm
Pack contents
User guide
USB cable
Fixing strap
SIM card (only for sending photos by email)
Please note that the SD card is NOT INCLUDED in the pack (max 32 GB)
Tips for storage and maintenance
Storage tips
In the event of non-use, store in a dry place away from light
TESTS AND WARRANTY
Warranty
2 Years